Order 3 wigs pay 2 (GET 1 FREE).

How to Detangle Curly Wig: Six Tips to Follow


  Our hair trends to tie itself in knots during the course of the day, especially when washing. But under no conditions should one simply try to pull out tangles. What will happen is that the tangled strands of hair will be ripped out of the scalp or the hair will be broken and damaged. So here are severals tips you should know. 

    Always detangle first before you wash or shampoo. Care must be used when washing the hair to avoid manipulating long strands in a direction that promotes tangling. Shampoo can be used gently from the top outward to the ends of the hair. Remember that the water temperature should be suitable. After that please put the hair in wram water mix with deep hair conditioner, take out 15mis later and use clean water wash again.


    When drying hair, pat it with a towel gently. Do not use any sort of rubbing motion as this will result in additional tangles. It’s best to let it dry naturally after shampooing or keeps blow dryer on low heat, long-term use of a hair dryer can make hair dry. 

    After removing excess moisture from the hair, a wide-toothed comb can be applied to the hair in small sections. Begin detangling from the ends of the hair, once the end is detangled, start detangling inch by inch to the middle then the root. This can minimizes knotting and breaking of hair. 

    Conditioner may be  applied directly to the hair and left in. Most conditioners contain ingredients that help detangle the hair. There are also spray on detanglers that can be applied in a light mist to the hair to aid in untying the knots and tangles. 


    A sleeping cap is also helpful. It can effectively fix the hair and prevent unconscious turning over and mess up the hair styling during sleep. At the same time, due to the isolation of the night cap, the friction between the hair and the pillow is reduced, which not only helps to reduce hair knotting but also protect the hair. 


Leave a comment

Name .
Message .

Please note, comments must be approved before they are published